Need an Engineer

About job

I need an electronics or electrical freelancer. I want to create a half-moon centrifugal pump on a flat base to simulate pressure, vibration and temperature changes. Pressure on the pump suction, stuffing box, and pump discharge by using a small air compressor. The air compressor can be inside the hollow pump motor or inside the yellow base plate of the pump (see attached image). I also want to place electronic heaters and vibration motors from the inside. These heaters and vibration motors would sit near the bearings and volute as shown attached. In addition, I want the ability to change the intensity of the heat, vibration, and pressure from the outside of the pump with adjusting knobs. This will be a total of 2 pump training displays that I need by December.